Packing support grating plate
:
Packing support grating plate
is also called hump type Support Plate, one of Standard Tower Internal. Mainly application is support the random packing or structured packing. Multibeam support liquid flux can reach 200m3/m2.h, and the pressure drop is 69Pa. It is suitable for bulk packing of various materials above 16mm. Therefore, the width of the side hole is set to the degree that the packing of 10mm will not leak out. For smaller packing, it can be Put a layer of 300mm high and slightly larger packing on the support plate first, and then pile up smaller packing

Feature:
It was assemble of many support beam units. Each support beam unit has many side pores. The characteristics as follows:
1:Excellent stiffness.High loading capacity to bear the extremely high pressure from packings and flowing liquids.2:Lightweight and economical.Metallic, plastic, ceramic and graphite materials for choice to suit different environments.3:Large open area.Stereochemical structure of multi-beam packing can help to enlarge open area, which can reach 100%.4:Wide range of opening available.Round, slot and various other opening patterns can be customized according to specific condition and requirements.5:Sectional design.Sectional design is standard for larger towers with manways. And this design make it easy for transporting and installation.6:Low pressure drop.The liquid and gas are moving through different path to avid the flowing interference. It can remain low pressure drop even under the high liquid and gas loading.7:Extremely high flux.The flux of liquid and gas of multi-beam packing support is superior to any types of supporting grid.8:High mass transfer efficiency.Special design make the liquid and gas evenly distributed and ensure the high mass transfer performance for the tower.

Installation Instructions
Installation
If the tower diameter is small, the grating plate can be welded onto the tower wall directly.When the tower diameter is large, the grating plate should be welded on the supporting ring or supporting plate for reinforcement.< 350 mm. Grating plate are welded onto the tower wall.> 350 mm. Grating plate should be welded onto the supporting ring on the tower wall.

Founded in
Pingxiang City of Jiangxi Province
in 1998, mainly engaged
in the
design and manufacture of tower internals, packing, tower trays and the process of energy saving. Mainly develop the production, test and engineering service of mass transfer and separation in Chemical, Petrochemical, Refinery, Fertilizer, Oil & Gas and Environmental Protection areas. With many years of technological development and production innovation, FXSINO has a very complete production equipment and strength. Widely cooperation with domestic famous Research institute & Multinational Group let FXSINO gain an unprecedented leap in the filed of production application recently.We provide our clients the best priced tower packing, trays and tower internals with good quality, practical utility and high - efficiency. Meanwhile, positively assist our customer resolve some questions which happened in project design, equipment commission, later maintenance& replacement etc.

Our Advantages

Application
It is suitable for supporting the corrugated structured packing and random packing.it is widely used in the following tower types:
Sulfuric acid absorption tower.Drying tower.Cooling tower.