✨Welcome to [JCD & QHTITEC] official store. ✅【All goods are in stock】 ✅【100% brand new and high quality】 ✅【We ship within 24-72 hours of your order】 ✅【You can receive the package within 7 to 15 days】

✨Welcome to [JCD & QHTITEC] official store. ✅【All goods are in stock】 ✅【100% brand new and high quality】 ✅【We ship within 24-72 hours of your order】 ✅【You can receive the package within 7 to 15 days】

USE Notice:1.After Each Use. It is Recommended to take 3-5 times of Empty Suction to Full the residual Tin in The Tube.2.If the interval is about 20 minutes, it is recommended to use a needle to clean the steel pipe after empty suction.3.During the use, If the suction is reduced. Please use a needle to clean the steel pipe.4.If you do not use often, it is recommended to adjust the tin gun to about 200 degrees, and then adjust to the workingtemperature when using it5.When there is about 1/2 of the tin slag in tin storage. It should be cleaned in time. When the filter Spong is hardness,Plsreplaced in time.6.The Reason For Block Desoldering Gun1)The temperature is set too low for long time desoldering, The solder Tin does not reach the storage tube,But the temperaturecomes down.So they Stayed in the tube,Make it Block 2)Did not clean in time when too much tin slag in the tin storage tube , This will effect the Gun's suction , In this case , youshould remove tail's tin slag . it can be removed only after you use the soldering iron to heat the tin until it melt

USE Notice:1.After Each Use. It is Recommended to take 3-5 times of Empty Suction to Full the residual Tin in The Tube.2.If the interval is about 20 minutes, it is recommended to use a needle to clean the steel pipe after empty suction.3.During the use, If the suction is reduced. Please use a needle to clean the steel pipe.4.If you do not use often, it is recommended to adjust the tin gun to about 200 degrees, and then adjust to the workingtemperature when using it5.When there is about 1/2 of the tin slag in tin storage. It should be cleaned in time. When the filter Spong is hardness,Plsreplaced in time.6.The Reason For Block Desoldering Gun1)The temperature is set too low for long time desoldering, The solder Tin does not reach the storage tube,But the temperaturecomes down.So they Stayed in the tube,Make it Block 2)Did not clean in time when too much tin slag in the tin storage tube , This will effect the Gun's suction , In this case , youshould remove tail's tin slag . it can be removed only after you use the soldering iron to heat the tin until it melt

Contact Person: Lucy ZhangEmail: lucyzhang@jcsolder.com

Contact Person: Lucy ZhangEmail: lucyzhang@jcsolder.com